| kirbyland |
Sun Jan 13, 2013 8:42 am |
|
| It seems as if there are a couple new options for putting a newer tunnel trans in an older split trans bus. Looks like the only alterations needed are to the nose cone-anyone use them yet? I read a long post a while ago- but there was many different opinions and creative ways people were doing the conversion- these look a lot cleaner/simpler/and better? What's the consensus on them? |
|
| TinCanFab |
Sun Jan 13, 2013 10:32 am |
|
| The nosecone kit from Concept1 as about as good as it gets. Rave reviews-their ad is on the featured classified section right now. If I owned a split case bus I would use it in a heartbeat. |
|
| EverettB |
Sun Jan 13, 2013 11:24 am |
|
We have a thread in the FAQ dedicated to this so I am going to direct you there:
Tunnel-case / Split-case nosecone mounts
The Concept 1 adapter is discussed beginning on page 2 of the thread above.
There is also another thread regarding this in the Bus FAQ:
Installing a tunnel transmission into an early split-case transmission Bus
But the one above is longer and more current |
|
Powered by phpBB © 2001, 2005 phpBB Group
|