TheSamba.com Forums
 
  View original topic: Rebuilding Solex 32 PBIC
vdubdan Sat Feb 14, 2009 6:18 pm

I am trying to rebuild a pair of Solex 32 PBIC carbs and need some advice. I need to but cannot remove the emulsion tube that runs down the middle of the throat of the carb. Does anyone know how to remove these? According to the rebuild diagram this tube comes off. Does anyone sell these tubes and or the jet that screws into the emulsion tube? I have two carbs that the top of the emulsion tube is broken. Thanks for the help.
Dan

a-train Sun Feb 15, 2009 2:43 pm

vdubdan wrote: I am trying to rebuild a pair of Solex 32 PBIC carbs and need some advice. I need to but cannot remove the emulsion tube that runs down the middle of the throat of the carb. Does anyone know how to remove these? According to the rebuild diagram this tube comes off. Does anyone sell these tubes and or the jet that screws into the emulsion tube? I have two carbs that the top of the emulsion tube is broken. Thanks for the help.
Dan

Ditto, same issue here, one of mine is broken..... Also, is there a good source for the bolts, screws, levers/springs to rebuild these? I already have the standard "rebuild kit"

Thanks,
A

John Moxon Mon Feb 16, 2009 1:34 am

Try here: http://www.356carburetorrescue.com/home.html

vdubdan Mon Feb 16, 2009 5:41 pm

Thanks John, Good advice!

Mr. Okrasa Sat Feb 21, 2009 12:56 pm

I restore these carbs!! See photo album below:

http://imageevent.com/mrokrasa/carburetorssolexzenithweber/solex32pbiccarbrestorerebuild




Powered by phpBB © 2001, 2005 phpBB Group