| wehrbüchse |
Mon Jan 11, 2010 4:29 pm |
|
Nope, haven't ordered it yet. I just sealed the hole so he can drive it to work in the meantime.
Probably not too wise? Do you guys think the pump pulley bearing will fail pretty quick here?
Ok, I'm gonna have him order a pump tonight. |
|
| Russ Wolfe |
Mon Jan 11, 2010 8:34 pm |
|
camerahunter wrote: Russ Wolfe said:
Quote: If it is a 1.9L, I have a New waterpump listed in the classifieds for a reasonable price.
What brand is it? I'm going to need one soon.
David
It is a german pump. I will have to go pull it out tomorrow and see what brand it is. (Meyle it think) |
|
| wehrbüchse |
Sat Jan 23, 2010 2:55 pm |
|
Sorry to resurrect the thread, just hoping you guys can chime in re: silicon gasket sealant.
Should I use it on the gaskets of my new pump and therm. housing? If so, what type?
Thanks bros. |
|
| sdtrojan |
Tue Sep 14, 2010 10:13 am |
|
can people plz share their experience with Holts products.
i'm leaking quite a bit of coolant, i think through the water jacket seal on the block... all my hoses and the rest of the coolant system is good.
so is the "wondarweld" product safe for rubber hoses? how is it applied?
(this sounds like the product i would need to fix my leeks)
"radweld total coolant system repair" may work for what i need but i'm unsure... I'm NOT looking to seal my radiator or anything... seems like purely a block seal leak.. it is clear that this product is dumped in the pressurized tank and safe for rubber hoses.
any recommendations on where to buy?
thanks for the help |
|
Powered by phpBB © 2001, 2005 phpBB Group
|