TheSamba.com Forums
 
  View original topic: torsion beam
[email protected] Thu Sep 26, 2002 11:19 pm

what is the procedure for pulling out leaves on a 67 bug, how low can i get it

[email protected] Fri Sep 27, 2002 10:07 am

It's a simple matter of removing the set screws that secure the trailing arms and
loosen the ones in the center of the torsion bar tubes. If you remove laminations, the
set screws won't have any thing to hold against, and your front end will fall apart.
Do it correctly and purchase an adjustable
or pre-lowered beam assembly. While you're
at it, invest in a blue Bentley shop manual.
all the procedures are laid out in there in
a very simple, easy to understand manner that
98% of us can understand.



Powered by phpBB © 2001, 2005 phpBB Group