| zzhayward |
Wed Jan 12, 2011 5:17 pm |
|
Does anyone have the machining specs for the rear brake rotors on a 1973 914? I would like to know the minimum thickness of the rotor so I can tell if mine are thick enough to have them turned.
Thank you, Joe |
|
| Bruce |
Thu Jan 13, 2011 12:44 am |
|
New are 9.5mm.
The min after machining is 8.9mm.
Then after doing that, the wear limit is 8.5mm. |
|
| Bleyseng |
Thu Jan 13, 2011 3:33 am |
|
| They used to be so cheap that if they needed turning you threw them away. |
|
| zzhayward |
Thu Jan 13, 2011 10:47 pm |
|
| I love this forum. I post a question and wonder of wonder, someone smiles and I get the information I need. Yea!!!!! I would't know how else to access some of this information.Thank you, Joe |
|
Powered by phpBB © 2001, 2005 phpBB Group
|