| JeffRens |
Sat Oct 17, 2015 12:32 pm |
|
| Redoing the rear axle seals on my Oval as I apparently trashed the large O-rings installing them wrong the first time. The question I have is do all of the axles have the same set-up and use the thin paper gasket between the bearing housing and the axle. If If install the O-ring around the bearing first, it doesn't allow the paper gasket to fit flush. If the O-ring seals, why is that gasket necessary anyhow? Thanks... Jeff |
|
| jason |
Sat Oct 17, 2015 2:41 pm |
|
I dont think splitcase trans uses them.
|
|
| EVfun |
Sat Oct 17, 2015 2:59 pm |
|
| The paper gasket is not used until about '65. If you are supposed to have item #12 (often missing) you are not supposed to use a paper gasket. |
|
| JeffRens |
Sat Oct 17, 2015 3:19 pm |
|
| Cool.... Thanks again as always....Jeff |
|
Powered by phpBB © 2001, 2005 phpBB Group
|