TheSamba.com Forums
 
  View original topic: My H6 Install (EZ30) Page: Previous  1, 2, 3, 4
xmass Thu Mar 30, 2017 7:13 am

Hi i'm in the process of swapping my 2.1wasserboxer for a subaru ez30D 2001 and i can't seem to find info on how to adapt the harness for the vanagon.
Ive seen for all the other subaru engine exept for H6.
Even if a will figure it by my self ( as an aicraft mechanic for 23 yrs i'm very resourceful ) it woud be nice to have couple hits and a pin out chart for the ecu.
I want to also install the subaru cruise control onto my westy at the same time.
If you guys have info on this please feel free to comment.
Thanks

levi Thu Mar 30, 2017 12:27 pm

I don't have the pinout info, but your fellow Canadian Tom shiels does.

Just Google tom shiels Subaru wiring harness.

xmass Thu Mar 30, 2017 5:30 pm

Than'k levi, lot's of info on tom sheild'd site 😁😁
Merci!😉

wesitarz Thu Mar 30, 2017 9:45 pm

Found this manual for 01 H6.See page 407 I think for the pin out.

http://jdmfsm.info/Auto/Japan/Subaru/Legacy%20Outback/2001/2001MY(H6).pdf

http://www.submariner.org/thepno95/Documents/2001_EZ30D_USDM_ECU_IO_SIGNAL.pdf

kpsamba Wed Jan 31, 2018 5:24 pm

Help! Need info as to how to connect Vanagon front and rear heater hoses and coolant fill tank to Subaru H6 3.0L engine heater hose connectors.!

Presently I have the coolant fill reservoir in parallel with the heater hoses and the flow of hot coolant to the front heater is extremely marginal/slow!

wesitarz Wed Jan 31, 2018 7:32 pm

Do you have a diagram of your cooling system?



Powered by phpBB © 2001, 2005 phpBB Group