| Urnge74 |
Sun Aug 18, 2013 3:03 pm |
|
anyone ever done this before?
I need to replace mine from a previous hit, I have the general idea on removal but would like to see a write up or ask someone who has done it before.
from what I can see, the panel is spot welded in across the gas tank support area and brazed where the body line/ windshield frame meets the fender.
what I need to know is:
where do I go from there? what else needs to be cut?
what do I do about the factory brazing when I install the new panel? |
|
| Foxx |
Sun Aug 18, 2013 5:55 pm |
|
| use search, it has been covered before in this forum. |
|
| Urnge74 |
Sun Aug 18, 2013 6:57 pm |
|
| I did and found no results but thanks anyway. |
|
Powered by phpBB © 2001, 2005 phpBB Group
|