| Adam91 |
Sun Sep 22, 2013 5:52 pm |
|
| Adjusting points and stripped the screw in an 009 distributor. is it really just as easy as getting an 8x32 screw and screwing it in? also I noticed my distributor shaft has a decent amount of up and down play. should I just replace? |
|
| Glenn |
Sun Sep 22, 2013 5:54 pm |
|
Yes, a larger SAE screw will work... unless you strip it also.
Up/down play indicates broken/work/missing fiber washers and/or shims.
It's like having too much endplay on the crankshaft. |
|
| Adam91 |
Sun Sep 22, 2013 5:58 pm |
|
| alright, i might just end up replacing the distributor then. it moves quite a bit. and ill try not to strip the next one. haha |
|
Powered by phpBB © 2001, 2005 phpBB Group
|