virtanen |
Sat Sep 28, 2013 9:29 am |
|
Here some pictures of welding of my sections to a '51 split.
Temporary screw fixed here.
First welds made and zinc primer sprayed over.
Rear end closing lip spot welded.
Gas welded here as original.
This is a special section with high rear area.
The correct height 43 mm here.
Basic straightening after welding made.
A final piece put here.
|
|
Matthew Tolbert |
Sat Sep 28, 2013 11:16 am |
|
[quote="virtanen"]Here some pictures of welding of my sections to a '51 split.
Mika,
Do you make and sell this piece? I have a set of complete channels but I hate to cut them for just this section. Seems like a waste to me but I will if necessary. |
|
virtanen |
Sat Sep 28, 2013 12:43 pm |
|
The heater channel section only for right side available so far, this was it's initial placement. |
|
VEE DUB BOYS |
Sat Sep 28, 2013 7:06 pm |
|
I enjoy looking at your work. You are a true craftsman. |
|
Matthew Tolbert |
Sun Sep 29, 2013 2:36 am |
|
Mika that just happens to be the side I need at the moment. If you would pm me a price if you don't mind. I need the quarter panel piece for that side also so I will probably get them at the same time.
Thanks |
|
Powered by phpBB © 2001, 2005 phpBB Group
|