TheSamba.com Forums
 
  View original topic: Source for Alternator rebuild kits for AL 82's?
Buckmaw Fri Dec 27, 2013 4:40 pm

I have a bad diode that is causing the GEN light to stay on after the key is off and removed from the ignition.

If anyone has a source for rebuild kits for this I would appreciate it.

kreemoweet Fri Dec 27, 2013 7:09 pm

There's no such thing as a "rebuild kit" for an alternator. Rebuilding an alternator is not something that can be done at the owner/small shop level. There are alternator parts outlets that list various parts
for the Bosch alternators used in aircooled VW's, such as http://www.aspwholesale.com/index.php. Regulators and brush assemblies for the Bosch Al-82 are sometimes available from a few
VW parts suppliers. They are not exactly cheap.

Do not buy an AL-82 regulator from CIP1 (if they still list it), as is typical for CIP1, it is a piece of bogus crap. As far as I can tell, genuine
Bosch (Brazil) regulators are still available.

johnnypan Sat Dec 28, 2013 10:31 am

kreemoweet wrote: There's no such thing as a "rebuild kit" for an alternator. Rebuilding an alternator is not something that can be done at the owner/small shop level. There are alternator parts outlets that list various parts
for the Bosch alternators used in aircooled VW's, such as http://www.aspwholesale.com/index.php. Regulators and brush assemblies for the Bosch Al-82 are sometimes available from a few
VW parts suppliers. They are not exactly cheap.

Do not buy an AL-82 regulator from CIP1 (if they still list it), as is typical for CIP1, it is a piece of bogus crap. As far as I can tell, genuine
Bosch (Brazil) regulators are still available.

:roll: :roll: :roll:

http://www.ebay.ie/itm/BOSCH-ALTERNATOR-RECTIFIER-DIODE-PACK-DIODES-X-3-POSITIVE-/310365286756

the stuff is out there,Bosch and the rebuilders control it to keep you from doing it at home..kick your search up a notch,check your local Bosch vendor too..sometimes schmoozing a parts guy pays off.

Hyperspace Sat Dec 28, 2013 12:40 pm

Appart from the diode , it is not too hard to replace the bearings, and clean things up. I put some NSK ones in with higher rateings than the originals.



Powered by phpBB © 2001, 2005 phpBB Group