| zopenshaw86 |
Tue Mar 18, 2014 7:23 pm |
|
| I have some rust issues in the cargo area floor area of my 79. the area i need replaced is the small horizontal line where the rear cargo floor ends and meets with the slanted area that goes up to the bed over the engine. just a little strip of rust through in that crease. what is this area called anyway and are there any replacement options? |
|
| skills@eurocarsplus |
Tue Mar 18, 2014 7:33 pm |
|
| if you are looking for the section where the cargo floor meets the smaller panel before it goes up over the gas tank /engine area there is no panel available that i know of. you will either have to make one or find a donor |
|
| zopenshaw86 |
Tue Mar 18, 2014 7:37 pm |
|
| my luck. being the only part of the floor that needs replacement |
|
| zopenshaw86 |
Tue Mar 18, 2014 7:42 pm |
|
| then again it wouldnt be bad to fab my own strip since the floor will cover it and it wont be seen. |
|
| zopenshaw86 |
Tue Mar 18, 2014 8:05 pm |
|
| which would be the better choice just fab a strip of my own and weld in or get one from a donor |
|
Powered by phpBB © 2001, 2005 phpBB Group
|