Beeble1 |
Thu Mar 20, 2014 9:24 am |
|
Upon the arrival of my country of origin plate, I immediately went to the garage to mount it. However, it doesn't fit my bumper mount. My bumper mount is too tall. When I ordered the plate, I ordered the one compatible with 49-67 cars, because the 74-79 plates have the round mount for the shock absorbing bumpers. I presumed that it would fit my car, since it doesn't have the shock absorbing bumpers.
This is the one I got:
http://www.mamotorworks.com/VW/product/origin-plat...low_361066
It says that you can buy an adapter plate, but it looks like this:
http://www.mamotorworks.com/VW/product/bracket-to-hold-country-sign-354713
Obviously I cannot use the adapter, since I don't have shock absorbing bumpers. What should I do? |
|
Glenn |
Thu Mar 20, 2014 9:27 am |
|
Send it back. |
|
Beeble1 |
Thu Mar 20, 2014 9:34 am |
|
Well that's the obvious answer... |
|
Volks Wagen |
Thu Mar 20, 2014 9:49 am |
|
Get someone to make you a bracket to replace the small bolt on clamp with a longer one that'll go down under and around your bumper bracket - something like this:
| |
U
Then you can put the 'D-sign' and holder in the middle of the long U and the bolts through the U and clamp the bracket above and below the bumper. Or send it back, or drill your bumper bracket, or weld it on. |
|
Powered by phpBB © 2001, 2005 phpBB Group
|