| KTPhil |
Thu Jun 23, 2016 2:31 pm |
|
| Also, are those the right shoe springs? Compare the photos above... your spring at the slave cylinder looks much smaller. |
|
| Eric&Barb |
Thu Jun 23, 2016 2:32 pm |
|
congerz83 wrote: I was able to aquire some OEM hardware from a friend... About ready to put the drum back on...
Is that an actual image of your brakes?? If so you need to replace those wheel cylinder boots, and probably take the cylinder apart for inspection and cleaning out. Then use a silicon grease like NAPA sells that works for brake cylinder grease to lube up the inside bore of the cylinder. |
|
| congerz83 |
Thu Jun 23, 2016 3:00 pm |
|
Eric&Barb wrote: congerz83 wrote: I was able to aquire some OEM hardware from a friend... About ready to put the drum back on...
Is that an actual image of your brakes?? If so you need to replace those wheel cylinder boots, and probably take the cylinder apart for inspection and cleaning out. Then use a silicon grease like NAPA sells that works for brake cylinder grease to lube up the inside bore of the cylinder.
I have the boots. I was just sizing up these springs. |
|
Powered by phpBB © 2001, 2005 phpBB Group
|