| clarkster75 |
Fri Jul 08, 2016 8:53 pm |
|
| Besides a clean connection, or best you can do, is there a good spot on the car to connect the ground to, or do you always want to be as close to the weld as possible. And, if you are just doing a part not on the car, is a steel table the way to go?.. Thx in advance. |
|
| chrisflstf |
Fri Jul 08, 2016 9:10 pm |
|
| Close to the weld is best. Steel tables are good |
|
| Danpa |
Sun Jul 10, 2016 5:18 am |
|
If you don't have a steel table, get a couple of alligator clips and a section of wire and use this to make a good ground connection between the two pieces till they are electrically connected by the weld.
Dan |
|
| planenut |
Sun Jul 10, 2016 7:38 pm |
|
| While I'm doing welding, I have a stud with a shoulder that I screw into a fender nut. Clean the metal, and use a longer bolt and nut, even. Just something to tighten against the metal, and long enough for your ground. |
|
| fabricator john |
Sun Jul 10, 2016 8:01 pm |
|
| i always liked the jacking point on a vw give it a lil wizz to make a clean spot , n go to town , ,,,,,,,,,,,,, fabricator john |
|
| 57BLITZ |
Wed Jul 13, 2016 1:58 pm |
|
| I sometimes clamp a pair of Vise-Grips on to the part I am working on and connect the ground clamp to the Vise-Grips. |
|
Powered by phpBB © 2001, 2005 phpBB Group
|