View original topic: Hand Crank Nut Page: Previous  1, 2, 3
ldj1002 Sat Mar 18, 2017 3:08 pm

I have the nut modified and setting on the bolt. I have another bolt ordered and when it comes I'll weld the nut to that bolt. I'll make video cranking it.

ldj1002 Mon Mar 20, 2017 1:26 pm

I have the hand crank finished. See video at youtube link below.
Is there a way to post video here like a image?

Al Capulco Mon Mar 20, 2017 1:49 pm

Good job, great looking bib overalls. You may want to tighten your fan belt.

sam_w Tue Mar 28, 2017 8:34 pm

What is the correct torque for the crankshaft nut?

Al Capulco Tue Mar 28, 2017 8:45 pm

29-36 ft lb for the crank shaft pulley bolt

Al Capulco Fri Mar 31, 2017 4:08 pm

Happen to find an original spring washer and "starting Claw" in the garage today. Inside diameter is about 25mm.

Powered by phpBB © 2001, 2005 phpBB Group