TheSamba.com :: View topic - VIN Plate for true identification of bus type?

Fri Jan 06, 2017 2:41 pm

Does anyone know the diameter of the pipe/tube that is talked about in this posting below that gets covered by the center pan?

I would like to add this pipe/tube to my bus. Although I went from 13 to now 21, I'm not doing it for correctness. I'm thinking adding the tube is the way to go to make sure if I ever need to fish an additional harness wire through i will be good to go.

olliehank47 wrote: InDaWeeds wrote: Thanks.
Anyone have good photos of this wire tube to look for?

Here's a photo of the wiring tube, with the center pan removed. It's on the bottom rail in this picture. With the center pan installed, you could not see this tube, but the openings will be in the cross member, passenger side front, next to the frame member. The rear opening, I believe, is not visible as it is covered by the frame tube for a short distance, rearward.

Here's another picture, from the top, near the rear torsion tube. You can see the tube inside the frame member. I'm not sure if you can see a hole on the outside where the tube exits or even the end of the tube because the frame member is covered a short distance from the front cross member and the wiring loom exits at that point. Some one with a true 21 can verify if the front end of the tube is visible.

Tue Jan 10, 2017 9:23 pm

^^^^^^^^^^^^^^
Anyone know the size of the tube that is welded on the rails that houses the Wiring Harness wires that is covered by the belly pans that I inquired about in the above post?