| surfbus23 |
Thu Nov 30, 2017 2:09 pm |
|
Is this the correct routing for the accelerator cable? Previous owner had installed a Type 1 engine and had it running in the hole to the left. Assuming the welded bracket is the correct location. It's also where my tin has a hole, but wanted to check as I don't know if the PO did any other modifications other than moving it to the other side. How's that tail look behind it? Seems like it might droop down on top of the transmission.
Also, is the cable itself in need of replacing? Might be a little kinky.
|
|
| surfbus23 |
Thu Nov 30, 2017 2:56 pm |
|
| Answer my own question. I was under there and bumped it and popped it through a bit more to the metal ring on the case. NOW it looks right. |
|
Powered by phpBB © 2001, 2005 phpBB Group
|