TheSamba.com Forums
 
  View original topic: Is there a reinforcement rail corner/end piece available?
ncpi Fri Mar 19, 2021 6:45 am

Working on putting in new floorboards on my 74 SB Convertible. The heater channels and reinforcement rails are in GREAT condition...except 2 holes about 1.5" in diameter near the very front of the driver reinforcement rail. I don't want to replace the whole rail for this, just about a 4" section. I have searched all the suppliers to see if just the end/corner piece is available to no avail. I don't want to buy (and ship) a full rail, does anyone make/sell just the corner piece? If I can't find one I will just fabricate pieces to weld in, but I would rather have the formed piece if possible.

Thanks,
Bill



Powered by phpBB © 2001, 2005 phpBB Group