| jbeaulie |
Fri Jun 23, 2023 4:21 am |
|
The fuel pump wires on my 1989 Westy (2.1L) have spade terminals, but many of the replacement pumps require ring terminals. While I don’t have a problem crimping ring terminals onto the wire harness, I would like to install a rubber dust boot to protect the connections from dirt, water, etc. I found them at a few overseas vendors, but would prefer a US vendor to save on shipping. Are any of you aware of a source?
https://www.merlinmotorsport.co.uk/p/electrical-te...-fac-fk002
Thanks,
Jake |
|
| space |
Fri Jun 23, 2023 5:49 am |
|
| https://www.ebay.com/itm/185831680564 |
|
| PDXWesty |
Fri Jun 23, 2023 10:03 am |
|
https://www.amazon.com/s?k=terminal+dust+boot&..._sb_noss_2
https://www.amazon.com/Fastronix-Small-Terminal-Co...mp;sr=8-19
Lots of choices and sizes if you look. |
|
Powered by phpBB © 2001, 2005 phpBB Group
|