| thatbaldwinlife |
Sat Jan 06, 2024 3:38 pm |
|
There are only a few wires to hook up. Red to power, brown to ground and white to illuminate. But when I push the odometer reset button, it blows the fuse every time. Looking at the wiring that GW supplied, the odometer button is wired to positive and negative and when you push it, it connects the two?
I sent GW an email but they are not open today. Anyone with this speedo have any insight?
thx
nate |
|
| thatbaldwinlife |
Sat Jan 06, 2024 4:40 pm |
|
Figured it out I think. Going over the wiring harness, GW switched two wires in the harness. They had orange going to the power on the gps unit and red to the odo switch. The red needs to go to the gps unit and orange is the odo reset.
Not sure how they made that mistake but in case someone else has this same issue!
I let GW know and will see what they say
nate |
|
| Zeitgeist 13 |
Sat Jan 06, 2024 4:42 pm |
|
| Just about to chime in about the orange wire thing. Good job! |
|
| thatbaldwinlife |
Sat Jan 06, 2024 4:56 pm |
|
I was racking my brain thinking I had done this super simple wiring wrong :). Glad they included a wiring diagram though I didn’t think to check the pdf for it till now
All working now!
Nate |
|
Powered by phpBB © 2001, 2005 phpBB Group
|