| Ted2 |
Fri Aug 23, 2024 6:51 am |
|
Hi Everyone,
I'm close to starting my engine rebuild. I'm looking for a recommendation for a mechanical oil pressure gauge to check the actual pressure.
Thanks |
|
| BulliBill |
Fri Aug 23, 2024 6:58 am |
|
I'd also be interested in suggestions for a small, fairly accurate oil pressure gauge to screw into the case hole to help diagnose a possible issue with a 36hp engine. Even better (but not necessary or required) would be a gauge and a fitting that allowed both the new gauge and the stock oil pressure switch to be used together on a 36hp engine. I imagine that many before me have figured this out (pictures of this would be nice). Thanks for any ideas/solutions...
Bill |
|
| heimlich |
Sat Aug 24, 2024 2:43 pm |
|
| I have this on my engines. I was trying to put a kit together but put the project to the side. I have a fitting that screws into the case. Then at the end the stock sensor screws in to it. On the side of the new fitting a gauge screws into it. They are 10MM fittings. Send me an email and we can discuss the parts I have. |
|
| heimlich |
Mon Oct 07, 2024 3:08 pm |
|
Here's the one I have. You can see all the pieces in the last picture.
https://www.vwnos.com/vwnos-1047 |
|
| KTPhil |
Mon Oct 07, 2024 3:18 pm |
|
| Is the case and sensor 10mm straight, or tapered (pipe thread style)? |
|
Powered by phpBB © 2001, 2005 phpBB Group
|