TheSamba.com Forums
 
  View original topic: Vanagon Drum Brake Adjusters
Chootrain470 Thu May 15, 2025 12:32 pm

I am rebuilding my rear drum brakes and have a question about the orientation of the automatic adjusters. I currently have the skinny side out and the beveled side out. Is this correct?




VicVan Thu May 15, 2025 1:07 pm

There are good pictures, and answers to your questions, in the FAQ if I remember correctly.

SCM Thu May 15, 2025 1:18 pm

VicVan wrote: There are good pictures, and answers to your questions, in the FAQ if I remember correctly.

Yeah but unfortunately a lot of photos are no longer visible and there's a search for "vanagon brake adjuster + thesamba" returns some unrelated and maybe even unreliable info.

Here's a starting point for your searching https://www.thesamba.com/vw/forum/viewtopic.php?t=655319&start=0

Chootrain470 Thu May 15, 2025 1:27 pm

Looking at photos, I am fairly certain that the skinny side, facing the rear of the van, of the adjuster faces out.

The end towards the front of the van is unclear. I have seen some photos with the bevel side out and some with it in. I'm not sure if its critical.

Chootrain470 Thu May 15, 2025 4:19 pm

https://youtu.be/b6H7QZicAyI?si=zro-CabubpMsdYEw

I found this video that goes into detail. I believe my current setup is wrong but at least I have only done one brake so far.

do.dah Fri May 16, 2025 10:41 am

https://www.thesamba.com/vw/forum/viewtopic.php?t=790933

Pay very close attention to what Crazyvwvanman says and shows on page 1.
Print it out and put it in your bentley, page 46.6.

Chootrain470 Fri May 16, 2025 2:56 pm

do.dah wrote: https://www.thesamba.com/vw/forum/viewtopic.php?t=790933

Pay very close attention to what Crazyvwvanman says and shows on page 1.
Print it out and put it in your bentley, page 46.6.

I was able to take my drum off again and fix this yesterday. Thanks.



Powered by phpBB © 2001, 2005 phpBB Group