| bnam |
Thu May 29, 2025 9:25 am |
|
I need to redrill the opening for the headlight switch as the previously butchered hole had to be welded shut. Borrowing a pic from another thread. I need the measurement "K6".
Thanks,
Byas |
|
| '40's guy |
Sat May 31, 2025 7:33 pm |
|
Hello Byas,
I have a 1958 Karmann Ghia. From center to center, the distance between each hole at K6 is 56mm.
Best regards,
Clayt |
|
| bnam |
Sat May 31, 2025 7:37 pm |
|
'40's guy wrote: Hello Byas,
I have a 1958 Karmann Ghia. From center to center, the distance between each hole at K6 is 56mm.
Best regards,
Clayt
Thanks Clayt! On FB I got a response of 58mm from a 61 car. Wonder if this is within the error range of measurements or whether later cars were indeed a bit more separated.
|
|
| Era Vulgaris |
Sun Jun 01, 2025 1:43 pm |
|
I still have what remains of my 64 donor car's dash. 58mm looks right
|
|
| TRS63 |
Mon Jun 02, 2025 11:07 pm |
|
K6 is also 58mm on my September 59!
Antoine |
|
| Jrhedman |
Sat Jun 07, 2025 1:35 pm |
|
I measured off of my 65' Ghia Convertible: I'd call it closer to 55mm, but it may just be my poor measuring abilities.
|
|
Powered by phpBB © 2001, 2005 phpBB Group
|