| matter396 |
Sun Jun 01, 2025 2:16 pm |
|
| Hey fellas I have a 3 rib bus tranny that has the three bolt throw out bearing sleeve. My tranny did not come with bolts or studs and I am in need of them,, can’t find a bolt to fit or studs anywhere, help!!!!??? |
|
| busdaddy |
Sun Jun 01, 2025 2:30 pm |
|
| It should be a common M6 stud, 20-25mm long, Ace hardware perhaps? |
|
| kreemoweet |
Sun Jun 01, 2025 2:35 pm |
|
| I think the threaded holes in the trans are M7. If you are in an isolated area with no vendors of M7 studs/bolts, you can get them online at, for instance, https://belmetric.com/ |
|
| busdaddy |
Sun Jun 01, 2025 2:49 pm |
|
| Now that you mention it M7 does ring a bell, please disregard my previous advice. |
|
| matter396 |
Sun Jun 01, 2025 3:44 pm |
|
| 7mm was right. Auto parts only not at ACE. O’Reillys saves the day. Thank you all!!! |
|
| SGKent |
Sun Jun 01, 2025 5:31 pm |
|
if we are talking the steel sleeve the TO slides on, the fiche gives the stud as 7mm x 32mm. It does not give the pitch.
Part N 014 449 2 up to 213 2 194 781
washer 7N 012 134 2
lock nut N 011 007
After 1973 they used a 7mm bolt x 15 mm long
Part N 040 203 3
Weddle has them https://weddleindustries.com/products/H-BM7X15H/H-BM7X15H M7 x 1.0 x 15mm
says use with specific lockwasher # H-WM7-STL
https://weddleindustries.com/products/H-WM7-STL/H-WM7-STL |
|
Powered by phpBB © 2001, 2005 phpBB Group
|