| daveg67 |
Wed Jul 16, 2025 9:43 am |
|
Hello
Im putting new bulb holders in my snowflakes
Question is where the bulb holder fits in the is a square tab that locates in to the bottom bur what is the purpose of the little hole at the top for is there another wire clip that is missing ?
Thank you Dave |
|
| Zwitterkafer |
Wed Jul 16, 2025 10:31 am |
|
| The square tab on the bulb-holder slips into the slot in the reflector, snug press fit alone holds it together. Any other small holes are insignificant. For the reflector, a hole might be used for hanging in the chrome plating process. On the bulb-holder, I dunno. I have found that adding a ground wire to the bulb-holder improves reliability and may even slow corrosion between the other parts. |
|
| daveg67 |
Wed Jul 16, 2025 11:04 am |
|
| yes bulb holder is a flush fit just wondered what the small hole was for !! |
|
Powered by phpBB © 2001, 2005 phpBB Group
|