| Rustybettle68$ |
Today 8:33 pm |
|
Have two questions about these torsion arms. The one pitted is it damaged beyond repair? Seems the major pitting is between the bearing and sleeve area. Second is the one with the end cap popped off. Is there a way to repair this? Are both of these issues a waste of my time? If so should I replace all four of them and who to purchase from? Thank you for any help.
|
|
| Schepp |
Today 9:02 pm |
|
They don’t look bad to me. What’s important is the bearing areas. I don’t see any pitting or wear marks in that area. How to the bearings look? That is most important too.
I see nothing wrong those parts. The cap you should be able to tap back on. You can stake it to prevent it from falling out again. |
|
| Rustybettle68$ |
Today 9:38 pm |
|
Schepp wrote: They don’t look bad to me. What’s important is the bearing areas. I don’t see any pitting or wear marks in that area. How to the bearings look? That is most important too.
I see nothing wrong those parts. The cap you should be able to tap back on. You can stake it to prevent it from falling out again.
Bearings don’t look to far gone. But I am replacing them with rebuild of front beam. So just wire wheel, light emery cloth, and some rust converter for the pitting? I’d only like to have to do this once for right now and hopes it will all last a couple of years |
|
Powered by phpBB © 2001, 2005 phpBB Group
|