| i van |
Mon Oct 04, 2004 2:24 pm |
|
| i am taking my bus back to the metal and am concerned about the backs of my doors as i cant get into them properly to remove the surface rust which is there,so my question is ;what is the best way to do this ? i have considered sand blasting but peoples views on this are mixed ,some say its good while others say it will damage my doors,so does anyone have any good ideas on the best way i can clean and treat the inside of my doors ready for a coat of paint? |
|
| k29349@yahoo |
Mon Oct 04, 2004 2:59 pm |
|
| I had the inside of my oval doors blasted. The guy that did mine knew what he was doing though. You can warp them if you're not careful. Mine came out warp free. I was worried but he said he had alot of experiance at blasting cars. Check the guy out real good. Don't just trust anybody with a sandblaster. |
|
Powered by phpBB © 2001, 2005 phpBB Group
|