Hello! Log in or Register
| Help | Donate | Buy Shirts ![]() |
See all banner ads | Advertise on TheSamba.com |
![]() |
|
|
Search found 232 matches |
Page: 1, 2, 3 ... 10, 11, 12 Next |
Author | Message |
---|---|
![]() |
|
binger59 Replies: 54 Views: 9792 |
![]() |
Decide to go the route of putting the igniter through the casting. I wonder if anyone used one of the two (what appear to be) casting ports? I致e included a photo for reference. Each casting has them. ... | |
![]() |
|
binger59 Replies: 557 Views: 101690 |
![]() |
A friend of my son's struck the van with a 4 wheeler. The SA lower grill was damage and since it's NLA I had to modify it. The third photo is after I modify
https://www.thesamba.com/vw/gallery/pi ... |
|
![]() |
|
binger59 Replies: 7 Views: 237 |
![]() |
Thanks for help everybody. | |
![]() |
|
binger59 Replies: 7 Views: 237 |
![]() |
There was some melt that happened. I was running 90/100 for a very brief period. I went over all the connections today. Everything looks good on the high and low wiring. | |
![]() |
|
binger59 Replies: 7 Views: 237 |
![]() |
I have to add that that I知 running the inner beams for the SA as well.
https://www.thesamba.com/vw/gallery/pix/2023242.jpg https://www.thesamba.com/vw/gallery/pix/2023241.jpg |
|
![]() |
|
binger59 Replies: 7 Views: 237 |
![]() |
Hello all,
I hope everyone is keeping busy (how can you not with a Vanagon) staying sane & safe. I'm currently running the SA headlight all the while running a relay setup. My high beams have bec ... |
|
![]() |
|
binger59 Replies: 12 Views: 1345 |
![]() |
I知 interested in a review, I知 considering this as a project. Running manuals now. | |
![]() |
|
binger59 Replies: 12 Views: 610 |
![]() |
Took a close look at an old harness and the splice is pretty straight forward like everyone said. Last question. New GW TPS, blue wire ground and black wire positive or the opposite? | |
![]() |
|
binger59 Replies: 12 Views: 610 |
![]() |
Pascal yes I posted about it in another thread.
https://www.thesamba.com/vw/forum/viewtopic.php?p=8620103&highlight=#8620103 |
|
![]() |
|
binger59 Replies: 12 Views: 610 |
![]() |
So if I知 going the other way from the 4 connection switch to the 2 connection can I just combine the 2 left wires and the 2 right wires together? I知 going the GW throttle body route. | |
![]() |
|
binger59 Replies: 28 Views: 4560 |
![]() |
There is a tighter radius with manual steering. I believe from getting a greater left/right distance in the rack. | |
![]() |
|
binger59 Replies: 28 Views: 4560 |
![]() |
I did the conversion on my 84" a few years ago. It was very straight forward in installation. Although I can't comment on the EJ22 part. I'm running a WBX. going from Manual to PS was such a grea ... | |
![]() |
|
binger59 Replies: 43 Views: 7744 |
![]() |
So I'm planning to purchase the GW throttle this winter and I wanted to run a question by the group. I have the early Vacuum setup. Can i just put the "T" in in the system to the regulator i ... | |
![]() |
|
binger59 Replies: 88 Views: 9471 |
![]() |
My update:
Think I have some leaks at the band clamps as well. The one clamp that I didn't use a walker clamp sounds like it's leaking. Although I took it off and added rtv it still "sounds" ... |
|
![]() |
|
binger59 Replies: 13 Views: 913 |
![]() |
New motor is from Vanistan. The fuel bits all came from previous motor and was working before I started the swap. I have since dug into some taped section of the harness and found completely bare wire ... | |
![]() |
|
binger59 Replies: 13 Views: 913 |
![]() |
All four injectors ohm out at 16.6 or 16.7. Found my little diode light hooked it up before I tested ohm. Flashed on driver side but not pass. Went back and tried driver side wouldn't flash again. EC ... | |
![]() |
|
binger59 Replies: 13 Views: 913 |
![]() |
Unless those two injectors are no good. I need to get a mood tester and see if they pulse. | |
![]() |
|
binger59 Replies: 13 Views: 913 |
![]() |
I have fuel coming from the driver side bank now. Only squirts when installed for some reason. | |
![]() |
|
binger59 Replies: 13 Views: 913 |
![]() |
Fuel pump primes and in sending fuel to the rail. Will the hall sender kill the injectors? | |
![]() |
|
binger59 Replies: 13 Views: 913 |
![]() |
Just installed a new motor and I can't get it to start. Spark but no signal to injectors. One bank of injectors fired (driver side) squirt and the pass side didn't. Now nether side do. Cleaned all the ... | |
Page: 1, 2, 3 ... 10, 11, 12 Next All times are Mountain Standard Time/Pacific Daylight Savings Time |