Hello! Log in or Register
| Help | Donate | Buy Shirts ![]() |
See all banner ads | Advertise on TheSamba.com |
![]() |
|
|
Search found 3246 matches |
Page: 1, 2, 3 ... 161, 162, 163 Next |
Author | Message |
---|---|
![]() |
|
ftp2leta Replies: 9 Views: 226 |
![]() |
Here are pics of my fuse panel before i ripped that POS apart.
It was working just fine WOW, you just save me and my customer a bunch of ours..... MANY thanks This van was empty when I g ... |
|
![]() |
|
ftp2leta Replies: 9 Views: 226 |
![]() |
Hi all, it as been a wile since I came here, I hope that all are fine.
If anyone as or could take a picture of a Vanagon AIr Cool fuse box (behind-See picture) that would help me a lot. Thanks, ... |
|
![]() |
|
ftp2leta Replies: 20 Views: 637 |
![]() |
Rod knock | |
![]() |
|
ftp2leta Replies: 16 Views: 634 |
![]() |
Probably because I sent Everett all your threatening PMs. smooches
All I did here for so many years is help people, all you did is being a... you know what. Mr Purist. No open mind at all, just ... |
|
![]() |
|
ftp2leta Replies: 16 Views: 634 |
![]() |
Very sad ending, you stay and I am out again, because of people like you that are so close minded. Mister purist | |
![]() |
|
ftp2leta Replies: 16 Views: 634 |
![]() |
That was specifically mentioned four posts back.
Yes my love ![]() Funny that you post, you are one reason that I left The Samba Ben |
|
![]() |
|
ftp2leta Replies: 16 Views: 634 |
![]() |
No one talk about the most important thing when swapping from auto-stick or the opposite.
Check the "End Play" of the crankshaft, you may need to add or remove a shim. [youtube]https: ... |
|
![]() |
|
ftp2leta Replies: 30 Views: 1042 |
![]() |
It's made in China, that is why. I have to buy 4 before I get one that doesn't buzz. BOSCH is not what it use to be.
Split one in 2, you will see China inside Ben |
|
![]() |
|
ftp2leta Replies: 8 Views: 306 |
![]() |
Hi, look like the optional gas heater as been remove
Ben |
|
![]() |
|
ftp2leta Replies: 38 Views: 1134 |
![]() |
After, fuel pressure test
http://www.benplace.com/fi_test.htm |
|
![]() |
|
ftp2leta Replies: 38 Views: 1134 |
![]() |
http://www.benplace.com/mark_subi1/mark_subi05.JPG | |
![]() |
|
ftp2leta Replies: 38 Views: 1134 |
![]() |
You need a multimeter! You need to check voltage at the black (yellow connector) in the junction box wile the IGN is at ON (not start).
Now listen, unplug that wire (IGN), on the fuse side, and hoo ... |
|
![]() |
|
ftp2leta Replies: 48 Views: 2490 |
![]() |
It should be pretty obvious if it's a CV, have someone look under wile your trying to put her in speed.
I have an old page about rebuilding - checking CV http://www.benplace.com/cv_joint_mainte ... |
|
![]() |
|
ftp2leta Replies: 16 Views: 567 |
![]() |
Check:
Fuel pump connector, firewall right front side Junction box black wire (IGN) with a yellow plug, check also that 5 amps fuse. Unplug the main round connector and plug it back. Ben |
|
![]() |
|
ftp2leta Replies: 38 Views: 1134 |
![]() |
it's not the ground strap, this one is mostly for the starter.
The main ground is in the battery box. For sure your problem is electric. Start by checking all connection in the battery comp ... |
|
![]() |
|
ftp2leta Replies: 21 Views: 814 |
![]() |
All van have 3 temps sensor, the one on the rad is called a Radiator Fan Switch
Ben |
|
![]() |
|
ftp2leta Replies: 11 Views: 1474 |
![]() |
Ben:
I would like to know if you had any issue with the clutch pedal travel? Even if I had the BRZ slave cylinder with a 21mm bore, I had to put a stopper on the clutch pedal to reduce the trave ... |
|
![]() |
|
ftp2leta Replies: 11 Views: 1474 |
![]() |
Nice of you,,, | |
![]() |
|
ftp2leta Replies: 11 Views: 1474 |
![]() |
The RS fab kit instruction are... well basic, Blame it of me being French spoken but more picture would be welcome. | |
![]() |
|
ftp2leta Replies: 11 Views: 1474 |
![]() |
Hi, I know it's been a wile, I am more on FB group lately ![]() I did a video on the kit and some mistake I made wile doing it, it may help some folks. I am also working on another video about th ... |
|
Page: 1, 2, 3 ... 161, 162, 163 Next All times are Mountain Standard Time/Pacific Daylight Savings Time |