Hello! Log in or Register   |  Help  |  Donate  |  Buy Shirts  See all banner ads | Advertise on TheSamba.com  
Search found 2 matches
Forum Index
Author Message
  Topic: Acceptable tin gap?

Replies: 16
Views: 972

PostForum: Performance/Engines/Transmissions   Posted: Sun Jun 03, 2018 11:58 am   Subject: Re: Acceptable tin gap?

Flip the valve cover bale over so the nibs are pointing down. That way the bale will be level from the pocket to the valve cover.

Good Luck.
  Topic: Acceptable tin gap?

Replies: 16
Views: 972

PostForum: Performance/Engines/Transmissions   Posted: Sat Jun 02, 2018 6:57 pm   Subject: Re: Acceptable tin gap?
Well guys, I was able to adjust some non-critical high points on the head casting and was able to get some tin to fit a little better. As seen in this picture, there is still about 3/16 in. gap where ...
Page 1 of 1
All times are Mountain Standard Time/Pacific Daylight Savings Time
Jump to:  

About | Help! | Advertise | Donate | Premium Membership | Privacy/Terms of Use | Contact Us | Site Map
Copyright © 1996-2018, Everett Barnes. All Rights Reserved.
Not affiliated with or sponsored by Volkswagen of America | Forum powered by phpBB