realrecycledjack
Samba Member
Joined: December 17, 2009
Posts: 5
Location: AUBURN HILLS MI
|
 Posted: Wed Mar 22, 2023 4:21 pm Post subject: Flywheel for a industrial engine 135 teeth 11 5/16 inch diamete |
 |
|
hope i am doing this correctly
i an thing to find a flywheel or a reference or a part number fort a specific flywheel .
i have had a flywheel like this in my hands so i know it exists . the vw fox uses a " single mass " flat face flywheel . on the vw fox from 1987 -1993
i need a very similar flywheel . it looks exactly the same except is is 1/4 inch larger . the fox flywheel is 10 1/8 in overall diameter and has 132 teeth
the one i want is 10 5/16 inches in overall diameter and has 135 teeth . .it is so close it is maddening . i need this for a brush fire truck with a pump driven by a VW DIESEL ADG 1.9 DIESEL . THIS IS AN VOLKSWAGEN INDUSTRIAL ENGINE this was made in approximately 2000 . so this is most likely off a vw engine of the vintage . for sure it is flat faced , single mass , inline , diesel engine ( may also be used on gas engines but almost for sure not air cooled engines . also it it bolts on to a standard vw bolt pattern crank shaft . the bolt pattern used to hold flywheels on vw rabbit , golf , jetta etc etc from 1975-1998 at least . any help is welcome
and will get this fire truck in service again .....
jack finn 248 xxxxx789 vvvvvvvvvparts 38o3 |
|
