| Author |
Message |
bugginpaul
Samba Member
Joined: December 31, 2009
Posts: 3
Location: Newcastle, UK
|
 Posted: Sat Nov 26, 2016 11:18 am Post subject: 57/58 body dimensions |
 |
|
Does anyone have, or know where I can locate some detailed drawings of body dimensions...?
I've had a bug come into my shop, and the rear looks to have had a shunt at some point in its life, and then repaired (badly) at another vw shop.
Telltale for me was the badly fitting wing, and then when I've measured up, the engine bay tapers down on the side trays by over an inch over the length of them...
Cheers in advance for any help!! |
|
| Back to top |
|
 |
panicman
Samba Member
Joined: December 18, 2011
Posts: 2328
Location: Canby, OR
|
| Posted: Sat Nov 26, 2016 12:51 pm Post subject: Re: 57/58 body dimensions |
|
|
Hopefully you get a faster resource than me.
I think the Bentley shop manual has very detailed dimensions for body alignment and repair. When I can get to mine, I'll see if they look like what you need. If they do, I can scan them and upload them.
You might see in the technical tab if someone has already done this. |
|
| Back to top |
|
|
bugginpaul
Samba Member
Joined: December 31, 2009
Posts: 3
Location: Newcastle, UK
|
| Posted: Tue Nov 29, 2016 11:56 am Post subject: Re: 57/58 body dimensions |
|
|
I'd not thought of checking the bentley manual!! I'll have a flick through it tomorrow  |
|
| Back to top |
|
|
Rathguten
Samba Member
Joined: January 31, 2011
Posts: 200
|
|
| Back to top |
|
|
pondoras box
Samba Member
Joined: March 22, 2004
Posts: 1272
Location: Eerie PA
|
| Posted: Wed Nov 30, 2016 7:01 am Post subject: Re: 57/58 body dimensions |
|
|
If I am understanding the dimensions correctly, the left door opening is 1mm larger than the right? Interesting.
_________________
Looking for anything from Hal Casey Motors out of Hamburg New York, from license plate surrounds to matchbooks.
1961 23 Window (Bobo)
1965 11 Window (Zelda)
1965 13 Window (Lucas)
1957 Oval ragtop
1988 Cabriolet VR6 conversion
Plus a lot of other rusty junk |
|
| Back to top |
|
|
panicman
Samba Member
Joined: December 18, 2011
Posts: 2328
Location: Canby, OR
|
|
| Back to top |
|
|
esde
Samba Member
Joined: October 20, 2007
Posts: 6156
Location: central rust belt
|
| Posted: Fri Nov 29, 2024 4:31 pm Post subject: Re: 57/58 body dimensions |
|
|
somewhere here on Samba there is a thread with convertible door gap info. I stumbled across it after I got my 56 vert but foolishly did not bookmark it
_________________
modok wrote:
Bent cranks are silent but gather no moss. I mean, ah, something like that. |
|
| Back to top |
|
|
WrennMetallWerks
Samba Member
Joined: December 06, 2007
Posts: 3202
Location: Rescue ca
|
|
| Back to top |
|
|
|
