Syncro skidplate support bars - who made them?

[r.e.wing_fc3s]

A year or two ago i had an idea to use the mounting points of the diesel carrier bar to mount a diagonal brace going to the gas engine skidplate bars. This long unsupported section is easily pushed up into contact with the engine/ trans. Then i noticed one of the vendors - gw or rmw had made them already along with another piece iirc that supported the driveshaft protection bars in the middle in a similar fashion. Pretty sure they had them on the baja rig. This is not the brace that gw currently sells for the crossmember that the trans bolts too. I already made those years ago. When i tried to find these items again recently they were no longer on any of the websites. Did anyone purchase these when available? Gw cant find any record of them. I plan on making them with a stout turnbuckle that will allow for pretensioning and adjustment anyway but just wondered if anyone bought them when available?
_________________
Reference Automotive: NW Washingtons Vanagon Specialist. (360)366-6965. referenceautomotive.com

[Sodo]

Is this what you’re looking for?

https://gowesty.com/products/driveshaft-and-engine-underrun-bar-supports-dd?variant=44077778239653
_________________


'90 Westy EJ25, NEW oil rings (!) 2Peloquins, 3knobs, SyncroShop pressure-oiled pinion-bearing & GT mainshaft, filtered, cooled gearbox.
'87 Tintop w 47k 53k, '12 SmallCar EJ25, cooled filtered original gearbox
....KTMs, GasGas, SPOT mtb