Ball Joint Beam

BumbleBuggy · Posted: Thu Mar 23, 2006 6:28 pm Post subject: Ball Joint Beam

Broke down my ball joint beam over the weekend. Was just wondering If there are any tricks or tips I should think about as I put it back together. Going to keep it pretty much stock. I might cut off and reposition the dampner mount a little lower because it won't clear the gas tank when I test fit the body. Will I regret it if I go without the dampner? Do I need to reinforce it with front end supports if it's going to be a street car?

Thanks,
Glenn
_________________
Thanks, Glenn
Captian of “The Jolly Rancher" '67 Type II.

kit.car · Posted: Thu Mar 23, 2006 9:17 pm Post subject:

Mine is a VW Bus style that is been relocated to the lower beam using exhaust style mounting brackets. I will get a couple of shoots tomorrow for you.
_________________
Joe


Hello! Log in or Register \| Help \| Donate \| Buy Shirts	See all banner ads \| Advertise on TheSamba.com

Forum Index -> Kit Car/Fiberglass Buggy/356 Replica		Share:
		Print View

	Forum Index -> Kit Car/Fiberglass Buggy/356 Replica	All times are Mountain Standard Time/Pacific Daylight Savings Time
Page 1 of 1