Author |
Message |
[email protected] Samba Member
Joined: October 23, 2002 Posts: 20
|
Posted: Wed Oct 30, 2002 6:55 am Post subject: Pan Installation |
|
|
I am getting ready to install new "THING" pans does anyone have any great advise to make it easier? |
|
Back to top |
|
|
[email protected] Samba Member
Joined: July 11, 2002 Posts: 16
|
Posted: Wed Nov 06, 2002 1:34 pm Post subject: Pan Installation |
|
|
Mine are about to go in too, though I'm having them professionally installed. So far, the biggest concern has been with the condition of the inner rockers, which now seem to be ok. Will post more on the install as it happens - hopefully some of it useful. |
|
Back to top |
|
|
TimGud Samba Member
Joined: March 03, 2002 Posts: 6459 Location: Rio Rico Arizona
|
Posted: Sat Nov 22, 2003 10:08 pm Post subject: |
|
|
It would be best to remove the body from the pan, take your time and cut as little as possible if need be to fit it. |
|
Back to top |
|
|
flamed74vwthing Samba Member
Joined: November 27, 2003 Posts: 21 Location: memphis
|
Posted: Mon Dec 08, 2003 10:15 pm Post subject: pan replace |
|
|
I agree dont cut away to much good metal I over lap where I can and stich weld both sides dont forget to seal the seams |
|
Back to top |
|
|
rgrsapper65 Samba Member
Joined: April 28, 2003 Posts: 38
|
Posted: Tue Dec 09, 2003 12:05 am Post subject: |
|
|
If you are using quarter panels, make sure you leave as much metal as possible to overlap. If you want to save some money use ghia quarters. they have a different stamp pattern then the thing pans but they fit perfectly. I got a complete set from JC Whitney and surprisingly enough they were pretty good. Mig welder is a must, works great. I used POR 15 top and bottom to seal seams....worked great. If you use POR 15 make damn sure you use plenty of the metal prep to etch the new pans. I didn't and had poor adheasion in spots. Good luck |
|
Back to top |
|
|
|