Author |
Message |
grimace007 Samba Member
Joined: August 30, 2006 Posts: 2673 Location: swampville, florida
|
Posted: Sat Dec 27, 2008 1:21 pm Post subject: factory deck height? |
|
|
so im having a hard time figuring this out, ive searched the samba, and looked through my bently.
i dont have an engine to check on ATM but on a 69mm stroke with a stock non decked case and stock mahle 85.5 what does the deck end up at ?
just a ballpark figure would be good _________________ Brian
68 sedan
Dallas Air Coolers
perrib wrote: |
Hey It is The Samba where well thought out rational answers can take a while and getting side tracked is normal. I was just lucky this time. |
cr@M wrote: |
No one has any personal responsibility these days. This country is sue happy. Intelligence is no longer a requirement, just an accessory. |
|
|
Back to top |
|
|
Beezerbob Samba Member
Joined: December 14, 2008 Posts: 13 Location: California
|
Posted: Sat Dec 27, 2008 1:37 pm Post subject: Deck |
|
|
AM doing the same, vw shop said ball park would be 85 to 90 thousands
I read on Berg never go less than .040 _________________ RJWILSON |
|
Back to top |
|
|
grimace007 Samba Member
Joined: August 30, 2006 Posts: 2673 Location: swampville, florida
|
Posted: Sat Dec 27, 2008 1:49 pm Post subject: |
|
|
well i know the minimum requirement. so around .085 or .090 ..
ill try searching through my bently again. _________________ Brian
68 sedan
Dallas Air Coolers
perrib wrote: |
Hey It is The Samba where well thought out rational answers can take a while and getting side tracked is normal. I was just lucky this time. |
cr@M wrote: |
No one has any personal responsibility these days. This country is sue happy. Intelligence is no longer a requirement, just an accessory. |
|
|
Back to top |
|
|
ALB Samba Member
Joined: August 05, 2008 Posts: 3483 Location: beautiful suburban Wet Coast of Canada
|
Posted: Sat Dec 27, 2008 4:13 pm Post subject: |
|
|
I read somewhere in Berg's writings that VW used deck height to control compression; approx .045" in the 1200 or 1300 up to .065" or so
with the 1600. Hope this helps. Al
PS- In Berg's technical article about deck height-
factory stock 1200cc- 0.042 to 0.047"
1500cc- 0.057 to 0.059"
1600cc- 0.064 to 0.069"
According to Mr. Berg "the 1500 and 1600 share the same head cc's so VW regulated the CR with the deck." _________________ On a lifelong mission to prove (much to my wife's dismay) that Immaturity is Forever!! |
|
Back to top |
|
|
|