Author |
Message |
PDXWesty Samba Member
Joined: April 11, 2006 Posts: 6247 Location: Portland OR
|
Posted: Sat Apr 25, 2009 11:16 am Post subject: Correct voltage at battery? |
|
|
Ok, I'm testing my electrical and charging system this morning and I wondered if anyone knew what voltage should be seen at the battery while the engine is running. With nothing on and the engine running, I get 13.75 volts at the battery. It's the same at idle and 2500 rpm. The battery is brand new and had 12.6 volts when measured.
Is 13.75 the correct output? Is this the function of the alternator or voltage regulator? I know my home charger floats up to 14.2-14.4 volts for a full charge. Is my charging system functioning properly? I see some others have measured upward of 14 volts at the battery when the engine is running.
Thanks in advance. |
|
Back to top |
|
|
Jamos Samba Member
Joined: July 08, 2005 Posts: 762 Location: Lake Tahoe, CA
|
Posted: Sat Apr 25, 2009 11:45 am Post subject: |
|
|
13.75v measured at the battery is acceptable.
The condition of the voltage regulator that is attached to the alternator will determine how many volts the alt puts out.
With the motor running, go back and measure the voltage directly at the alternator. You will probably be at or a little above 14v. There is some voltage loss in the cable run up to the battery compartments.
My alt started putting out about 13v, which is still probably good enough if the rest of your electrical is in good shape and you don't run down your batteries often, but I decided to replace the voltage regulator anyway. After replacement, I am now showing 14.6v at the alt and 14.2v at the batteries with the motor running.
You're probably fine especially if you are using a home charger from time to time. Keep an eye on the voltages every once in a while to see if anything changes over time. _________________ '86 Wolfy Westy Weekender
2020 Audi Q5 |
|
Back to top |
|
|
Wildthings Samba Member
Joined: March 13, 2005 Posts: 50352
|
Posted: Sat Apr 25, 2009 6:40 pm Post subject: |
|
|
13.75 volts is probably fine for a place like Portland that doesn't see much of any really cold weather. |
|
Back to top |
|
|
PDXWesty Samba Member
Joined: April 11, 2006 Posts: 6247 Location: Portland OR
|
Posted: Sat Apr 25, 2009 8:05 pm Post subject: |
|
|
I also checked under load and it drops to 13.4 with the high beams on. Not the worst but not new either. |
|
Back to top |
|
|
|