| Author |
Message |
camerahunter
Samba Member
Joined: July 23, 2009
Posts: 567
Location: Tacoma
|
 Posted: Fri Sep 02, 2011 12:52 am Post subject: |
 |
|
Justin,
Sounds like your throttle position switch is out of whack to me.
Adjust that and see what happens.
Thank you,
David
_________________
1984 - Daily driver |
|
| Back to top |
|
 |
AnmlMthrM60
Samba Member
Joined: July 10, 2007
Posts: 228
Location: Prescott, AZ
|
| Posted: Fri Sep 02, 2011 5:53 pm Post subject: |
|
|
Thank you David, I now concur. After a little bit of digging on here and messing around with mine, I have a better understanding of how this thing should work. I get a click close to WFO but no click near CFC. So I think some adjusting is in order or a new cam. However, nothing happens if I reach under it and click it by hand in the closed position.
I did find my throttle cable is frayed under the boot and the return spring isn't pulling the throttle body CFC either. If I close it by hand it drops an additional 100rpm or so.
_________________
Justin
-------
86 Syncro - 2.2L WBX
69 Bug - 1776cc |
|
| Back to top |
|
|
prpent
Samba Member
Joined: September 30, 2009
Posts: 18
Location: MONTANA
|
| Posted: Sat Sep 03, 2011 7:39 am Post subject: |
|
|
| No progress ecu,idle stabalizer,idle module all replaced starts revs to 3000 and dies. still no vibration with key on at the idle stabilzer and no power to any of the wires attaching to the idle module, very confusing and over my head . Fortunately I live in montana and can not be driven in the winter (2wd doka) so I have all winter to play with it. temp sensor replacement is my next stop. |
|
| Back to top |
|
|
morymob
Samba Member
Joined: November 09, 2007
Posts: 4683
Location: east-tn
|
| Posted: Sat Sep 03, 2011 12:29 pm Post subject: |
|
|
| Just because the tps clicks don't mean it's good, verify with a meter.You stated-when u ground relay, idle control valve vibrates, right? Then will it idle ok?? |
|
| Back to top |
|
|
prpent
Samba Member
Joined: September 30, 2009
Posts: 18
Location: MONTANA
|
| Posted: Fri Sep 21, 2012 1:37 pm Post subject: fixed the doka |
|
|
| power brake assist vacuum hose came off. Yes it was avery big vacuum leak |
|
| Back to top |
|
|
Ahwahnee
Samba Member
Joined: June 05, 2010
Posts: 9808
Location: Mt Lemmon, AZ
|
| Posted: Fri Sep 21, 2012 3:20 pm Post subject: |
|
|
| Please tell me it didn't take a year to find it! |
|
| Back to top |
|
|
prpent
Samba Member
Joined: September 30, 2009
Posts: 18
Location: MONTANA
|
| Posted: Fri Sep 21, 2012 4:21 pm Post subject: |
|
|
| been looking on wrong end of the vehicle took mechanic 2 hours to find |
|
| Back to top |
|
|
|
