| Author |
Message |
SL12572
Samba Member
Joined: April 13, 2011
Posts: 270
Location: Washington
|
 Posted: Fri Jul 26, 2013 11:05 pm Post subject: Help! Need some measurements on a Syncro with the stock WBX |
 |
|
Can someone help me by providing some measurements in the engine bay of a Syncro with WBX? Need the following:
1. Top of bellhousing to engine deck lid.
2. Left valve cover to side of engine compartment
3. Right valve cover to side of engine compartment
4. End of crank pulley to back of engine compartment
Thanks!
Scott |
|
| Back to top |
|
 |
sanchius 
Samba Member
Joined: May 03, 2007
Posts: 1456
Location: IN
|
| Posted: Sat Jul 27, 2013 8:12 am Post subject: Re: Help! Need some measurements on a Syncro with the stock |
|
|
1. Top of bellhousing to engine deck lid: 25mm to bottom of deck lip (this is the engine case next to the center water pipe, not the slightly higher engine case ridge a few mm rearward of the pipes)
2. Left valve cover to side of engine compartment: 16.5mm to frame
3. Right valve cover to side of engine compartment: 15mm to frame
4. End of crank pulley to back of engine compartment: 2.5mm to tin shroud |
|
| Back to top |
|
|
|
