Author |
Message |
1981 Ed Samba Member
Joined: September 24, 2017 Posts: 18 Location: Alberta
|
Posted: Sun Oct 22, 2017 2:34 pm Post subject: 1981 bell housing to engine mounting |
|
|
Putting my power train back together. Engine to tranny going together and the way it came apart had 2 studs from engine case on bottom through trans case, a nut and bolt by the clutch slave bracket through engine case and tranny case but a d shaped headed bolt in the bellhousing through The trans case ear to mount starter but it does not go through the engine case..... there is a hole in the engine case that lines up with the hole in trans case but this special bolt is there
3 bolts hold engine and trans.
Cases together? Would it be better to get a longer bolt to go through both cases and through starter mounting pulling them all together or did the Germans have it right? |
|
Back to top |
|
|
ajdenette Samba Member
Joined: February 15, 2009 Posts: 768 Location: Hope Valley RI
|
Posted: Sun Oct 22, 2017 6:44 pm Post subject: Re: 1981 bell housing to engine mounting |
|
|
The top starter bolt goes through the starter the bell housing and the top passenger side engine hole and a nut clamps all three together the Vanagons typically had a long hex bolt but the other VW's used the D shaped bolt with a nut that could be tightened from the engine side. _________________ 1985 2wd Westy with 2000 Subaru 2.2 current driver
https://www.thesamba.com/vw/forum/viewtopic.php?t=685635
1986 Syncro Doka Project next in line
https://www.thesamba.com/vw/forum/viewtopic.php?t=732777
1990 Vanagon Syncro Base awaiting body work |
|
Back to top |
|
|
Wildthings Samba Member
Joined: March 13, 2005 Posts: 50338
|
Posted: Sun Oct 22, 2017 8:39 pm Post subject: Re: 1981 bell housing to engine mounting |
|
|
Pull the starter back out and then start the bolt through the hole in the starter and then slip the starter and bolt up into position. |
|
Back to top |
|
|
1981 Ed Samba Member
Joined: September 24, 2017 Posts: 18 Location: Alberta
|
Posted: Mon Oct 23, 2017 7:28 am Post subject: Re: 1981 bell housing to engine mounting |
|
|
Thank you... |
|
Back to top |
|
|
|