Author |
Message |
gears Samba Member
Joined: October 28, 2002 Posts: 4391 Location: Tamarack, Bend, Kailua
|
Posted: Sat Jul 29, 2017 6:00 pm Post subject: The difference between Bug & Van transaxles |
|
|
One of the best stories told to me during my one year in Denver (1970) was of a couple hippy dudes at the junk yard. They had an old van with a rapidly deteriorating transaxle, so decided to install one from the local recycle. They did the entire job in the parking lot .. pulled the old trans, changed over the axles, tubes, and reduction gears etc.
Yeah, you guessed it. They had installed a Bug trans without flipping the ring gear. The result was 4 gears reverse, and one very low forward gear. It was late in the evening, and they had to get home somehow ..
3rd gear, backwards, on the Freeway!! _________________ aka Pablo, Geary
9.36 @ 146 in '86 Hot & Sticky
'90 Syncro Westy SVX
'87 Syncro GL 2.5
https://guardtransaxle.com |
|
Back to top |
|
|
rockerarm Samba Member
Joined: December 16, 2009 Posts: 3552 Location: Los Angeles
|
Posted: Sun Jul 30, 2017 9:20 am Post subject: Re: The difference between Bug & Van transaxles |
|
|
Too funny.
Similar story here. My first dealer job back in the early '70's and one of the mechanics was installing the bus axle's and reduction boxes onto his rear engine buggy. He failed to heed the warnings from the unit repair guy of the impending result. Didn't even check its function while still on the hoist.
Puts buggy onto the shop floor, starts it up, into 1st gear , lets the clutch out and proceeds to back up into his tool box! |
|
Back to top |
|
|
SOLiiD Samba Member
Joined: June 01, 2016 Posts: 141 Location: in the hot
|
Posted: Tue Aug 29, 2017 4:05 am Post subject: Re: The difference between Bug & Van transaxles |
|
|
I'm a noob to the air cooled world... why's the ring need to be flipped? I thought all the AC Trans were in the same way. _________________ 72 Super RIP
70 Baja |
|
Back to top |
|
|
Zundfolge1432 Samba Member
Joined: June 13, 2004 Posts: 12468
|
Posted: Thu Jan 11, 2018 1:06 pm Post subject: Re: The difference between Bug & Van transaxles |
|
|
SOLiiD wrote: |
I'm a noob to the air cooled world... why's the ring need to be flipped? I thought all the AC Trans were in the same way. |
Five months later this guy deserves an answer dontcha think?????
Because reduction gears are stacked coming off drive axle to stub axle it reverses rotation. Therefore you can remove the ring gear and put it on other side. Haven’t seen one in awhile but they used to make adapter to mount reduction gear boxes into bug and it gave a few inches more ground clearance.
Neat ..... |
|
Back to top |
|
|
|