Author |
Message |
burner208 Samba Member
Joined: November 11, 2016 Posts: 223
|
Posted: Wed Dec 05, 2018 6:03 pm Post subject: Adjustable ball joint beam 1966 |
|
|
Wheres a good place to buy adjustable factory length beams? Mine is shot, fronts been lowered 2 inches.
Also, is there a easy way to tell if the rear has been lowered? Id like to return it to stock if its not been. |
|
Back to top |
|
|
KTPhil Samba Member
Joined: April 06, 2006 Posts: 34011 Location: Conejo Valley, CA
|
Posted: Wed Dec 05, 2018 6:06 pm Post subject: Re: Adjustable ball joint beam 1966 |
|
|
The rear can be gauged by the camber angle, but you need a very accurate measurement. Ride height is probably the most meaningful measurement anyway. |
|
Back to top |
|
|
rcooled Samba Member
Joined: September 20, 2008 Posts: 2506 Location: Santa Cruz, CA
|
Posted: Thu Dec 06, 2018 10:57 am Post subject: Re: Adjustable ball joint beam 1966 |
|
|
burner208 wrote: |
Wheres a good place to buy adjustable factory length beams? |
Here's a couple of adjustable beams. One genuine VW and one reproduction. And they're both on sale now at CIP1
https://www2.cip1.com/ProductDetails.asp?ProductCode=C24%2D113%2D401%2D021%2DFCSP
https://www2.cip1.com/ProductDetails.asp?ProductCode=ACC%2DC10%2D4198
burner208 wrote: |
Also, is there a easy way to tell if the rear has been lowered? |
Just eyeballing it should get you close enough. Measure the distance from the ground to the lip of a rear fender at the highest point of the arc (the ruler should be in-line with the center of the wheel). For stock height, the measurement should be around 25 ¾". _________________ '63 Ragtop (current)
'65 Ghia coupe (totaled)
'67 Ghia convertible (current)
'69.5 Ghia convertible and
'62, '63, '65, '69 Bugs (all long gone) |
|
Back to top |
|
|
burner208 Samba Member
Joined: November 11, 2016 Posts: 223
|
Posted: Sat Dec 08, 2018 12:22 am Post subject: Re: Adjustable ball joint beam 1966 |
|
|
Im looking for the whole suspension. Id like to replace everything. Anybody build such a kit? |
|
Back to top |
|
|
A Avina Samba Member
Joined: March 31, 2007 Posts: 274 Location: SantaAna Calif
|
Posted: Tue Dec 11, 2018 8:24 pm Post subject: Re: Adjustable ball joint beam 1966 |
|
|
If your in SoCal give Griffins Machine a call. They rebuild and sell stock beams. They are located at 7311 Madison st #B Paramount CA (562-531-4320) |
|
Back to top |
|
|
|