Author |
Message |
Glenn Mr. 010
Joined: December 25, 2001 Posts: 76911 Location: Sneaking up behind you
|
Posted: Thu Oct 01, 2020 3:29 pm Post subject: Fuel tank sender |
|
|
So a good friend has a 77 Bay with the stock fuel gauge and an aftermarket sender and it's not accurate. So he replaced it 2 more times and it's never right.
Anyone know a source for a aftermarket sender that works correctly with the stock gauge or is she I in the hunt for a good used sender? _________________ Glenn
74 Beetle Specs | 74 Beetle Restoration | 2180cc Engine
"You may not get what you pay for, but you always pay for what you get"
Member #1009
#BlueSquare |
|
Back to top |
|
|
ivwshane Samba Member
Joined: May 19, 2011 Posts: 1920 Location: Sacramento ca
|
Posted: Thu Oct 01, 2020 3:41 pm Post subject: Re: Fuel tank sender |
|
|
The sender usually requires modification such as bending the float rod. I had the same issue and after bending the rod (on a full tank to reflect a full tank) it now reads correctly. _________________ 77 westy 2.0 FI
69 ghia coup 1600dp
70 single cab |
|
Back to top |
|
|
busdaddy Samba Member
Joined: February 12, 2004 Posts: 51128 Location: Surrey B.C. Canada, but thinking of Ukraine
|
|
Back to top |
|
|
SGKent Samba Member
Joined: October 30, 2007 Posts: 41031 Location: Citrus Heights CA (Near Sacramento)
|
Posted: Thu Oct 01, 2020 4:38 pm Post subject: Re: Fuel tank sender |
|
|
even with the VDO gauge, a new dash VR and a new gauge you have to bend the arm to set it. Use a wooden yard stick to lift the float thru the filler if the tank is out and bend gently until it reads correctly. _________________ “Most people don’t know what they’re doing, and a lot of them are really good at it.” - George Carlin |
|
Back to top |
|
|
wagohn Samba Member
Joined: June 24, 2014 Posts: 740 Location: United States
|
Posted: Fri Oct 02, 2020 7:25 am Post subject: Re: Fuel tank sender |
|
|
I replaced our dead sender and the new sender was way off. We then manually tracked fill-ups and mpg with an app, and using that data, adjusted the float height by bending the float arm. Took two or three attempts to get it "spot on" but now it's accurate.
We cut an access hole - better than pulling the engine 3x to adjust. _________________ 1976 VW Transporter, 2.0 FI Engine |
|
Back to top |
|
|
|