Rocker Arm Geometry

CBDZ_CBDZ · Posted: Mon Apr 19, 2021 11:24 pm Post subject: Rocker Arm Geometry

Building a 2054 (94x74). Deck is set at .065"

While setting up the geometry, I am getting results where the shim pack below the rocker stand is greater than .121" and I will need to get longer than standard push-rods.

Does this seem normal, or should I be looking for something that isn't quite right?
_________________
Tube Bender Rental in So. Cal.

http://www.rentabender.com

mark tucker · Posted: Tue Apr 20, 2021 8:30 am Post subject: Re: Rocker Arm Geometry

some ting wong. and why the wide deck hight?that can induce detonation as well as hot spots and exsessive carbon...well not as exsessive as .100 deck..

ZEKE65 · Posted: Tue Apr 20, 2021 9:08 am Post subject: Re: Rocker Arm Geometry

What type of adjusters are you using?
_________________
1965 VW Sedan, 1968 C10 Step BB, 99 C5

Ohio Tom · Posted: Tue Apr 20, 2021 10:29 am Post subject: Re: Rocker Arm Geometry

You gotta be looking at it wrong.

.120" of shim is out of control.


Hello! Log in or Register \| Help \| Donate \| Buy Shirts	See all banner ads \| Advertise on TheSamba.com

Forum Index -> Performance/Engines/Transmissions		Share:
		Print View

	Forum Index -> Performance/Engines/Transmissions	All times are Mountain Standard Time/Pacific Daylight Savings Time
Page 1 of 1