vdubrookie
Samba Member
Joined: May 12, 2017
Posts: 306
Location: Battle Creek,Mi
|
 Posted: Tue Jul 13, 2021 6:35 pm Post subject: Re: Swing axle mounting |
 |
|
| I had an issue with my Berrien sand rail tearing up boots. I cut Two 3/16" aluminum flat stock spacers to fit between the bell housing & rear mount. Gave me just enough clearance so no more torn up boots. Did have to oval out the holes in bell housing slightly to get bolts in place as the spacers & mounts are on a taper. \ / But my nosecone mount was not toast like the one in the Pic;s |
|
