Author |
Message |
VanagonHaus Samba Member
Joined: June 04, 2019 Posts: 13
|
Posted: Sat Oct 16, 2021 4:15 pm Post subject: Crank, no start | NO SPARK FROM DISTRIBUTOR?? |
|
|
New battery, new distributor (replaced today and timing not set yet as van won't start) and a new coil. I get a spark at the cable that connects the coil to distributor but I get no spart out of the sparkplug cables. I'm assuming the cable that connects the power to the distributor isn't grounded or there is a fuse issue.
I've checked two separate cables and same result, also fuel pump works and I've heard the injectors pulse.
Can anyone point me in a good direction here, I would appreciate it!
Last edited by VanagonHaus on Sun Oct 17, 2021 4:26 pm; edited 1 time in total |
|
Back to top |
|
|
whafalia Samba Member
Joined: January 28, 2009 Posts: 685 Location: San Francisco
|
Posted: Sat Oct 16, 2021 5:44 pm Post subject: Re: Crank, no start | NO SPARK AT SPARKPLUGS? |
|
|
You put the rotor in? _________________ 84 westie 2.2 w/ digijet, AT |
|
Back to top |
|
|
VanagonHaus Samba Member
Joined: June 04, 2019 Posts: 13
|
Posted: Sat Oct 16, 2021 7:13 pm Post subject: Re: Crank, no start | NO SPARK AT SPARKPLUGS? |
|
|
Yup, I've been reading and have boiled it down to the part of the wiring harness that connects to the distributor / hall sensor. Must be a loose wire inside the connection piece. Will have to double-check tomorrow to see if my hunch is right.. |
|
Back to top |
|
|
davlance01 Samba Member
Joined: May 10, 2013 Posts: 224 Location: Ohio
|
Posted: Sat Oct 16, 2021 8:46 pm Post subject: Re: Crank, no start | NO SPARK AT SPARKPLUGS? |
|
|
If it started before all the new parts then its your installation of the parts. _________________ Life is short and the road is long so if you want to see it all you have to drive fast! |
|
Back to top |
|
|
djkeev Samba Moderator
Joined: September 30, 2007 Posts: 32574 Location: Reading Pennsylvania
|
|
Back to top |
|
|
DanHoug Samba Member
Joined: December 05, 2016 Posts: 4770 Location: Bemidji, MN
|
Posted: Sun Oct 17, 2021 6:11 am Post subject: Re: Crank, no start | NO SPARK AT SPARKPLUGS? |
|
|
lift your rotor off again and double check the orientation of the rotor notch in the distributor shaft notch. sometimes you THINK it is aligned and pushed down when it is indeed riding on top of the shaft. while the cap is off, make sure the carbon button in the center of the cap is not broken/missing. _________________ -dan
60% of what you find on the internet is wrong, including this post.
'87 Westy & '89 Westy both 2.1 4spd
Past projects can be found at--
www.thefixitworkshop.com |
|
Back to top |
|
|
|