| Author |
Message |
tar356
Samba Member
Joined: February 16, 2022
Posts: 11
Location: CA
|
 Posted: Tue May 24, 2022 2:47 pm Post subject: 1964 tail light locations |
 |
|
I have a set of repop rear fenders for my '64 that have no mounting holes for the tail lights.
I've been searching the forums, but can only find the tech bulletin that references dimensions from "earlier" holes.
Does anyone have a the hole locations/measurements they can share? I will be mounting the original '64 lights.
Thanks,
Todd
Orange, CA |
|
| Back to top |
|
 |
sportin-wood
Samba Member
Joined: September 12, 2010
Posts: 2008
Location: Texas
|
| Posted: Wed May 25, 2022 12:13 pm Post subject: Re: 1964 tail light locations |
|
|
Maybe this will help (from the gallery):
_________________
.
Paused 66 project bug
.
"Relax, all right? My old man is a television repairman. He's got this ultimate set of tools. I can fix it." --- Jeff Spicoli |
|
| Back to top |
|
|
sportin-wood
Samba Member
Joined: September 12, 2010
Posts: 2008
Location: Texas
|
|
| Back to top |
|
|
Slow-N-Rusty
Samba Member
Joined: March 09, 2020
Posts: 105
Location: SoCal
|
| Posted: Wed May 25, 2022 1:27 pm Post subject: Re: 1964 tail light locations |
|
|
I took some measurements off my fender for reference. The measurements off the cut out for the bumper bracket are measured off the center top of the hole.
|
|
| Back to top |
|
|
sportin-wood
Samba Member
Joined: September 12, 2010
Posts: 2008
Location: Texas
|
| Posted: Wed May 25, 2022 2:48 pm Post subject: Re: 1964 tail light locations |
|
|
Nice!
_________________
.
Paused 66 project bug
.
"Relax, all right? My old man is a television repairman. He's got this ultimate set of tools. I can fix it." --- Jeff Spicoli |
|
| Back to top |
|
|
tar356
Samba Member
Joined: February 16, 2022
Posts: 11
Location: CA
|
| Posted: Wed May 25, 2022 2:52 pm Post subject: Re: 1964 tail light locations |
|
|
Thanks guys, that what I needed!
Todd
Orange, CA |
|
| Back to top |
|
|
Slow-N-Rusty
Samba Member
Joined: March 09, 2020
Posts: 105
Location: SoCal
|
| Posted: Wed May 25, 2022 8:10 pm Post subject: Re: 1964 tail light locations |
|
|
Out of curiosity I double checked the measurements I took from one fender and checked them against the other side and found there was some variation between them (2-5mm). Both my rear fenders are the originals so I suppose those are just small variances that happened during original assembly.
I doubt you would notice that amount of variation between sides so it doesn't seem like enough to be a concern but I thought I would note it. |
|
| Back to top |
|
|
|
