Author |
Message |
mondshine Samba Member
Joined: October 27, 2006 Posts: 2769 Location: The World's Motor Capital
|
Posted: Fri Dec 30, 2022 3:50 pm Post subject: Weber IDF Question |
|
|
I have come across an old Italian Weber 36 IDF 16.
The carburetor top is unusual in that it has brass tubes (as bowl vents ?) running from near the bottom of the bowl to an inch or so above the top.
Anyway, carburetor top casting is broken at the fuel inlet.
So which Weber tops are compatible with this carburetor?
Thanks, Mondshine |
|
Back to top |
|
|
SGKent Samba Member
Joined: October 30, 2007 Posts: 41031 Location: Citrus Heights CA (Near Sacramento)
|
Posted: Fri Dec 30, 2022 4:14 pm Post subject: Re: Weber IDF Question |
|
|
I'd call http://www.redlineweber.com/ _________________ “Most people don’t know what they’re doing, and a lot of them are really good at it.” - George Carlin |
|
Back to top |
|
|
modok Samba Member
Joined: October 30, 2009 Posts: 26785 Location: Colorado Springs
|
Posted: Fri Dec 30, 2022 5:25 pm Post subject: Re: Weber IDF Question |
|
|
Most 36 and 40 idf tops could fit more or less.
Some of the 40IDF the top diameter is machined to 40mm but as cast they are about 38
Most tops.... where those high speed enrichment tubes goes is not machined, but could be drilled. |
|
Back to top |
|
|
Alstrup Samba Member
Joined: July 12, 2007 Posts: 7213 Location: Videbaek Denmark
|
Posted: Fri Dec 30, 2022 5:35 pm Post subject: Re: Weber IDF Question |
|
|
Its a Trijet carb. Originally designed as an aftermarket part (kit) for ACVW 13/1600 dual port, Fiat 131 1300 Mirafiori and Alfa Romeo 1200 ti (Before Alfa did their own dual carbed ti and some Ford Escort 1300 engines.
you can use any 36 mm IDF top on the body. You just have to rejet for regular twin system use. _________________ https://www.thesamba.com/vw/forum/viewtopic.php?t=435993 |
|
Back to top |
|
|
mondshine Samba Member
Joined: October 27, 2006 Posts: 2769 Location: The World's Motor Capital
|
Posted: Fri Dec 30, 2022 5:49 pm Post subject: Re: Weber IDF Question |
|
|
Alstrup wrote: |
Its a Trijet carb. Originally designed as an aftermarket part (kit) for ACVW 13/1600 dual port, Fiat 131 1300 Mirafiori and Alfa Romeo 1200 ti (Before Alfa did their own dual carbed ti and some Ford Escort 1300 engines.
you can use any 36 mm IDF top on the body. You just have to rejet for regular twin system use. |
Thanks for that... Never seen one before.
Thanks Modok. |
|
Back to top |
|
|
CrazyTestPilot Samba Member
Joined: May 05, 2022 Posts: 208 Location: Seattle, WA.
|
Posted: Wed Feb 01, 2023 10:25 am Post subject: Re: Weber IDF Question |
|
|
I thought the tubes sticking up were to help keep debris out of the carb...?? |
|
Back to top |
|
|
|