Anyone know the gap for pertronix

[neophish7]

Reciept says 1847v as a part # (009 distributor 1973 17 liter)
lost the little plastic shim and was wondering if i could use a feeler gauge?

[rccbusfreak]

Set the air gap between the module and magnet sleeve using the plastic feeler gauge (.030" thick). This is done in the same manner as points. Note: In some kits the modules are stationary and do not require air gapping.
_________________
71 Westfalia
68 Transporter
71 Transporter parts bus (the bus that keeps on giving)
LudwigUSA

[spiffy]

you might want to experiment with the gap to get the dwell where you want it. I had to set mine a little closer to get my dwell lower ( it was at 60 wit a .030 gap on mine) Or read ratwells write up on dwell and the pertronix.
http://www.ratwell.com/technical/PertronixAdjust.html
_________________
78 Riviera
67 Riviera

www.rivieraregistry.com